Specific operating steps for adjusting air pressure of air compressor

2025,03,30

The steps for adjusting air pressure for different types and brands of air compressors are slightly different. The following are the general steps.

First, make sure the air compressor is stopped and powered off to ensure safe operation. Then find the pressure adjustment device of the air compressor, which is usually on the control panel or near the air tank. It may be a knob, button or pressure regulating valve.

If you are using a knob-type adjustment device, slowly turn the knob. Clockwise rotation will increase the air pressure setting value, and counterclockwise rotation will decrease the air pressure setting value. For buttons, press the "+" key to increase the air pressure setting and press the "-" key to decrease. For a pressure regulating valve, adjust by turning the pressure regulating valve handle, turning it in a specific direction to change the air pressure setting.

After setting the target air pressure value, turn on the power to start the air compressor. After the air compressor runs steadily, observe the value changes on the air pressure gauge. When the air pressure reaches the set value, the air compressor should be able to automatically shut down or enter the pressure maintaining state; if the air pressure does not reach or exceeds the set value, it is necessary to shut down and cut off the power again, and re-fine-tune the pressure regulating device until the air pressure can be accurately stabilized at the set value.

Dongguan Shengshi Weiye Machinery Technology Co.The main equipment produced are: Liquid Die Forging Machine, low-pressure Casting Machine, Gravity Casting Machine, cold forging machine, hot forging machine, etc

Author:

Ms. Hu

E-mail:

dgliheng168@163.com

Phone/WhatsApp:

+86 13509684273