To improve the operating efficiency of Hydraulic Stamping Press, there are several points to remember!

   Hydraulic Stamping Press is an energy-saving and efficient hydraulic press that uses a servo motor to drive the main transmission oil pump, reduce the control valve circuit, and control the hydraulic press slide. It is suitable for stamping, die forging, press fitting, straightening and other processes.

1. For hydraulic press equipment that has been shut down for more than 4 hours, before starting work, the hydraulic pump motor should be started for 5-10 minutes before working under pressure. When a failure occurs in the hydraulic system, the operator cannot move without permission and should report to the maintenance department immediately. Hydraulic equipment should be cleaned frequently to prevent dust, cutting fluid, cutting chips, cotton yarn and other debris from entering the fuel tank.

 

2. In winter, when the oil temperature of the fuel tank does not reach 25°C, each execution mechanism cannot start working in sequence, but can only start the hydraulic pump motor to make the hydraulic pump work empty. During summer operations, when the oil temperature in the tank is higher than 60°C, pay attention to the operating conditions of the hydraulic system and notify maintenance personnel to deal with it. The operator cannot damage the interlocking device of the electrical system, cannot push the electronic control valve by hand, and cannot damage or arbitrarily move the position of each operating gear.

 

3. The operator must understand the principles of the hydraulic system, understand the functions of the main hydraulic components of the equipment, and master the operating procedures of the system. Before starting the equipment, you should check whether all moving mechanisms and solenoid valves have entered the initial state, and check the oil level in the fuel tank. If an abnormality or lack of oil is found, you should stop starting the hydraulic pump motor and find a repairman for repair. Operators should frequently check the working status of the hydraulic system, observe the operating pressure and speed, check the size of the workpiece and the wear status of the props, to ensure that the hydraulic system operates smoothly and reliably.

 

   Dongguan Shengshi Weiye Machinery Technology Co., Ltd. specializes in the production of Forging Press, Deep Drawing Hydraulic Press, Gravity Casting Machine, Four-column Servo Press, C Type Pneumatic Press and other machines. Friends in need are welcome to pay attention and learn more.